Back to Blog Gray Nest thermostat displaying 63 degrees on a white wall

Photo by Dan LeFebvre on Unsplash

November in Southern California is deceptive. For most of October, you barely touched the thermostat. Then one morning the house is 61 degrees, you flip the heat on, and three weeks later your utility bill looks like it belongs to someone in Minnesota. What happened?

It's not one thing — it's usually four or five things landing at the same time. Some are unavoidable. Some are signs that your HVAC system is working harder than it should. And a few are fixable right now, before the bill gets worse. Here's what's actually driving the spike, and what Inland Empire homeowners can do about it.

The Big Reason: Your System Just Woke Up from Eight Months Off

In Southern California, most home furnaces and heat pumps spend roughly April through October doing nothing — or close to it. When temperatures drop in November and you switch from cooling to heating, your system is starting from scratch. The first few weeks of heating season are almost always the least efficient weeks, for a few reasons.

First, the air temperature differential is at its widest. On a cold morning in Murrieta or Temecula, the gap between your indoor setpoint — say, 70°F — and the outdoor air temperature can be 25 to 35 degrees. The larger that gap, the more your system has to run to maintain it. As November wears on and your home's thermal envelope catches up, run times often normalize. But in that first billing cycle, the system is working overtime.

Second, your home has been leaking heat all summer without you noticing. Weatherstripping compresses and fails. Door seals dry out in SoCal's summer heat. Gaps around window frames that were invisible when you were running the AC suddenly matter a great deal when you're trying to keep warm air inside. The same leaks that let conditioned air escape in July now let your expensive heated air escape in November.

What Your HVAC System Is Actually Doing Differently

When you switch to heat, your system's fuel source and operating cost change entirely. Central air conditioners move heat — they're highly efficient at it, which is why their electricity use per BTU is relatively low. A gas furnace burns fuel directly. A heat pump running in heating mode uses electricity to move heat rather than generate it, which keeps costs manageable — but only if the system is well-maintained and correctly sized.

The biggest efficiency killer for a heating system that's been sitting idle is a dirty heat exchanger or clogged burner assembly. Dust and debris accumulate inside a gas furnace over the summer. When it fires up for the first time in fall, that fouling reduces combustion efficiency. The system still heats your home — it just burns more gas doing it. You pay the difference on your bill.

Similarly, a heat pump that hasn't been serviced since spring may have a refrigerant charge that's drifted slightly low, dirty coils from months of outdoor exposure, or a defrost cycle that's not working properly. Any of those conditions means the system runs longer to achieve the same result.

Modern heat pump unit installed outside a home for efficient heating

Photo by alpha innotec on Unsplash

Thermostat Habits That Cost More Than You Think

November is also when thermostat behavior changes — and not always in ways that save money. A few patterns that show up on bills every year:

  • Cranking the setpoint to warm the house faster. Setting your thermostat to 78°F when you want 70°F doesn't heat your home faster — it just makes your system overshoot and run longer. Your HVAC heats at the same rate regardless of the target number. Set the temperature you actually want and let the system get there.
  • Forgetting the summer schedule. If you have a programmable or smart thermostat, your summer cooling schedule is likely still active. That schedule may be holding the house at a higher temperature during the day than you need it in winter — or doing the opposite and letting it drift cold all day, forcing a big recovery cycle every evening.
  • Supplemental electric heaters running alongside the central system. Portable space heaters are expensive to run. If your central system is working properly, you shouldn't need them in most rooms. If certain rooms are chronically cold even with the furnace running, that's a duct balance or insulation issue — not something a space heater actually solves.
  • Keeping the fan set to "ON" instead of "AUTO." Running the blower continuously circulates air even when no heating or cooling is happening, which moves unconditioned air through the system and adds to the electricity draw. Set to "AUTO" unless a technician has told you otherwise.

The Fixes That Actually Move the Needle

// November Action List

Five Things to Do Right Now

1. Schedule a fall heating tune-up. A technician will clean the heat exchanger or coils, check the burner assembly or refrigerant charge, test ignition and safety controls, and confirm the system is running at rated efficiency. This is the highest-ROI thing you can do if the system hasn't been serviced since spring. · 2. Update your thermostat schedule. Flip from cooling mode to heating mode. Set a setback temperature for overnight and daytime hours when the house is empty — even a 4-degree setback saves meaningfully over a full billing cycle. · 3. Check your weatherstripping and door seals. Run your hand around exterior door frames and sliding glass doors on a cold morning. If you feel airflow, you're heating the outside. Foam or rubber weatherstripping is inexpensive and takes 30 minutes to replace. · 4. Replace the air filter. A clogged filter reduces airflow across the heat exchanger, forcing the furnace to run longer and in some cases triggering a high-limit safety shutoff. November is the right time to start heating season with a fresh filter. · 5. Check your vents and registers. Make sure supply vents are open and unobstructed in rooms you're heating. Closing vents in unused rooms doesn't save money the way people expect — it actually creates pressure imbalances that make the system work harder.

When the Bill Spike Is Actually a Warning Sign

A moderate increase in your heating bill at the start of November is normal. A dramatic one — or one that persists and grows through December without explanation — deserves a closer look. A few things that drive outsized heating costs and don't fix themselves:

  • A cracked heat exchanger. Beyond the energy waste, this is a safety issue on gas furnaces. If your furnace smells musty or metallic when it first kicks on, or if anyone in the house notices headaches or flu-like symptoms during heating season, have the heat exchanger inspected before you use the system again.
  • An undersized or aging system struggling to keep up. An HVAC system that's 15+ years old and running constantly just to maintain setpoint is working far harder than it should — and your bill is showing it. This is the kind of situation where a professional evaluation of system size, efficiency, and remaining life makes financial sense.
  • Duct leaks dumping heated air into unconditioned space. Attics and crawlspaces across the Inland Empire are full of duct connections that have loosened over years of thermal expansion and contraction. If your ducts leak significantly, you may be paying to heat your attic more than your living room.
  • A heat pump stuck in emergency heat mode. Heat pumps have a backup electric resistance heating element for extremely cold days. If that element is running continuously — either because the heat pump is malfunctioning or because the thermostat was accidentally set to emergency heat — your electricity bill will climb fast. Check your thermostat display to confirm it's not running in emergency heat mode unnecessarily.

The Bottom Line on November Bills

Some of the November spike is physics — colder air, bigger temperature differential, more run time. That part you can't entirely avoid. But the part that comes from an unmaintained system, a thermostat schedule stuck in summer, or weatherstripping that gave out in August? That part is recoverable. A fall tune-up, a thermostat update, and a few simple weatherization checks can meaningfully lower what you pay through the rest of heating season — not just this month.

Heating system running harder than it should? AirNova Tech serves homeowners and property managers across Murrieta, Temecula, Menifee, Lake Elsinore, Wildomar, Hemet, Perris, Riverside, Corona, and throughout the Inland Empire. Call (949) 848-2820 or request a service visit online — we'll diagnose the problem and get your system running efficiently before the bills get worse.